Yamaha Sound Edge Owner's Manual download pdf (Page 40)

Sound Edge Application Software

Apply Echo

Now let’s apply an echo effect. You’ll need to increase the Surround output level on the right

Output Mixer to audition the amount of echo while modifying the setting.

9. Click the [Output Mixer] box to open the Output Mixer setup dialog box, then click and drag

the [Surround] fader to increase the Surround output level to maximum position. There are

two Output Mixers. Set both to the same value.

Double click the [Control Menu] box in the upper left corner to close the Output Mixer.

10. Click the [Surround] box. The Surround setup dialog box appears.

11. On the left side of the setup dialog box, increase the input level by clicking and dragging

both [L/R] level faders to maximum positions.

12. Drag the [red point] on the left side of the upper (R) Delay Design box to the position on

the right as shown in the above illustration.

£The red colored graph indicates feedback delay time and volume. Time location (unit = ms [millisecond]) will

be displayed on the upper right side of the Delay Design box as you drag. Also, the red point in the lower (L) delay

design box will automatically move according to the delay time that you previously designated, above.

£By listening to your voice while you make settings, you can better judge the amount of echo applied.

£After moving a red point, a black point will appear in the red point’s original position.

(Red)

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 86 87

No comments

Yamaha Sound Edge Owner's Manual Page 40