Yamaha Sound Edge Owner's Manual download pdf (Page 10)

Sound Edge Setup

MIC TYPE: Lets you switch back and forth between two types of amplifier configurations

depending on the type of microphone connected. (3-lead condenser or dynamic microphone;

2-lead condenser microphone.)

1 1-2 Short/3-4 Open: 2-lead condenser microphone (such as the one included with Sound Edge).

2 1-2 Open/3-4 Short: 3-lead condenser microphone or dynamic microphone.

* Default position is 1.

OUTPUT TYPE: Lets you select whether to use the internal amplifier on the sound card or

not. Default is set to use the internal amplifier. When using an external amplified speaker,

do not use the internal amplifier. (In this case, use external audio devices having more than

10 kΩ input impedance.)

1 4-6 Short: Outputs the right channel without going through the internal amplifier.

2 3-5 Short: Outputs the left channel without going through the internal amplifier.

3 2-4 Short: Outputs the right channel via the internal amplifier.

4 1-3 Short: Outputs the left channel via the internal amplifier.

LEFT CHANNEL OUTPUT: Lets you select whether to output the left channel to the sound

card’s OUTPUT jack or not. (The left channel signal is always output to the computer’s

internal speaker.) Normally, you should leave this as the default, to output the left channel

signal to the sound card’s OUTPUT jack.

1 3-4 Short: Outputs the left channel to the sound card’s OUTPUT jack.

2 3-4 Open: Outputs the left channel only to the computer’s internal speaker.

* If you wish to use only the computer’s internal speaker, select 2 as shown above and connect an appropriate

audio cable to

RIGHT CHANNEL OUTPUT: Lets you select whether to output the right channel to the

sound card’s OUTPUT jack or not. (The right channel signal is always output to the

computer’s internal speaker.) Normally, you should leave this as the default, to output the

right channel signal to the sound card’s OUTPUT jack.

1 1-2 Short: Outputs the right channel to the sound card’s OUTPUT jack.

2 1-2 Open: Outputs the right channel only to the computer’s internal speaker.

* If you wish to use only the computer’s internal speaker, select 2 as shown above and connect an appropriate

audio cable to

. (Connecting the audio cable to

will automatically designate the right channel output to the

computer’s internal speaker.)

PC-SPK (Computer speaker): Lets you input system (“beep”) sounds. The system

sounds come from the computer’s internal speaker via the sound card.

* To hear the system sounds from the computer’s internal speaker via the sound card, unplug one end of the

connector of the audio cable extended from the computer’s internal speaker and connect it to

INTERNAL LINE IN: Lets you input stereo line-level signals from an MPEG board. You

can apply effects to the input signals using application software such as EffectGear.

* Connect the MPEG board’s output connector to

MIDI IRQ NUMBER: Lets you select the IRQ (Interrupt Request) number for triggering

the internal AWM synthesizer sounds when playing DOS games. The default is set to 9.

(See pages 5, 16 and 67 for more information.)

¢You may need to change the MIDI IRQ number if some conflict problem occurs. Please consider which

number to use before the sound card installation.

1 2

12 12

Ground Pin

L Input Pin

Ground Pin

R Input Pin

: Indicates the Jumper is set to short (ON) position.

: Indicates the Jumper is set to open (OFF) position.

Ground Pin

L Output Pin

R Output Pin

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 86 87

Comments to this Manuals

No comments

Yamaha Sound Edge Owner's Manual Page 10

Comments to this Manuals

Related products and manuals for Synthesizer Yamaha Sound Edge