Yamaha MTX3 User Manual download pdf (Page 79)

Example 3) Using cascade mode to add MTX input channels (analog connection)

MTX Setup Manual

Making XMV settings

If necessary, use the XMV’s front panel to make settings such as the high pass filter. For more about the settings you can

make on the XMV, refer to the XMV owner’s manual.

Verifying that the settings were applied

The main items to verify are listed below. For details on each parameter setting, refer to “MTX Editor User’s Manual.”

Recall the Basic preset.

Using the oscillator in the “ROUTER” screen, adjust the output level.

Adjust the amp’s attenuator value to an appropriate level.

Specify the gain from the microphone.

You can set the gain in the dialog box that appears when you press the parameter recall button for a port or external

device of an input channel in the “MAIN” screen. Watch the input meter, and adjust the setting appropriately.

Set the input levels and output levels.

Using the input/output faders in the “MAIN” screen, adjust the levels. As necessary, apply the output limiter in the

“CHANNEL EDIT” screen to prevent your speakers from being damaged.

Adjust the amp attenuator values to obtain the optimal S/N ratio.

In addition, make FBS settings as necessary.

Store the Basic preset.

Store by overwriting the previously-specified content.

Check the DCP settings.

Verify that the DCP operates as you expect.

When you have finished making all settings, save the project and switch MTX Editor offline.

This completes the settings for example 3.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 128 129

No comments

Yamaha MTX3 User Manual Page 79