Yamaha MTX3 User Manual download pdf (Page 68)

Example 3) Using cascade mode to add MTX input channels (analog connection)

MTX Setup Manual

In this example, make the settings shown in the above illustration. Clicking a cross point (a square area) or dragging

cross points will switch it on/off. If you right-click on a cross point, a context menu appears. You can select [All OFF]

to turn off all cross points. The cross point shows the send level as the amount of green.

With these settings, all input signals other than the microphone at the chairman’s seat (CH8 of ID=1) are handled in the

same way. To give the microphone at the chairman’s seat higher priority than the other signals, it is assigned to 1

Pri-

ority in the following “ZONE” screen. When CH8 is turned on in MATRIX, the signal from the matrix (attenuated) will

be combined with the signal from Priority, and output together.

For the input channel faders in the lower left of the screen, the grayed-out faders show input levels, and the other faders

show input channel send levels. Grayed-out faders cannot be operated in this screen.

PRIORITY

DUCKER

ANC

AMBIENT

SOURCE

From INPUT CHANNEL POST ON 1-16

*1 From YDIF IN 1-16

From ANC BUS 1-2

From STEREO INPUT CHANNEL POST ON 1L-3R

ZONE 1-8

ZONE OUT

To YDIF

OUTPUT

PATCH

MIXMIX

2nd PRIORITY 1st PRIORITY ANC

PRIORITY

SOURCE

PRIORITY

SOURCE

From DIRECT INPUT POST ON 9-16

PRIORITY

DUCKER

METER

MASTER

LEVEL

GR GR

AMBIENT

METER

To other MTXs

*1 DISTRIBUTION MODE only

Priority signal flow

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 128 129

Comments to this Manuals

No comments

Yamaha MTX3 User Manual Page 68

Comments to this Manuals

Related products and manuals for Processors Yamaha MTX3