Yamaha MTX3 User Manual download pdf (Page 102)

Example 4) A system using Dante

MTX Setup Manual

102

In this example, make the settings shown in the illustration in before page. Clicking a cross point (a square area) or

dragging cross points will switch it on/off. If you right-click on a cross point, a context menu appears. You can select

[All OFF] to turn off all cross points. The cross point shows the send level as the amount of green.

For each zone, this setting will be as follows.

Zone 1: Input channel 1, CD/BGM/SD (SDIN1–3), and the audio from the other MTX system are broadcast to this

entire MTX system. Since the mic (CH1) of this MTX system and the mic (CH9) of the other MTX sys-

tem are assigned for emergency announcements etc. for the entire building, specify their Priority in the

“ZONE” screen that follows.

When you turn CH1 and CH9 on in the matrix, the (attenuated) signal from the matrix will be combined

with the signal from Priority, and output.

Zone 2: This is for broadcasting the voice from the main mic (CH1) to the other MTX system.

Zone 3: This is for broadcasting signals other than the main mic to the other MTX system.

For the input channel faders in the lower left of the screen, the grayed-out faders show input levels, and the other faders

show input channel send levels. Grayed-out faders cannot be operated in this screen.

PRIORITY

DUCKER

ANC

AMBIENT

SOURCE

From INPUT CHANNEL POST ON 1-16

*1 From YDIF IN 1-16

From ANC BUS 1-2

From STEREO INPUT CHANNEL POST ON 1L-3R

ZONE 1-8

ZONE OUT

To YDIF

OUTPUT

PATCH

MIXMIX

2nd PRIORITY 1st PRIORITY ANC

PRIORITY

SOURCE

PRIORITY

SOURCE

From DIRECT INPUT POST ON 9-16

PRIORITY

DUCKER

METER

MASTER

LEVEL

GR GR

AMBIENT

METER

To other MTXs

*1 DISTRIBUTION MODE only

Priority signal flow

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 128 129

Comments to this Manuals

No comments

Yamaha MTX3 User Manual Page 102

Comments to this Manuals

Related products and manuals for Processors Yamaha MTX3