Yamaha MTX3 User Manual download pdf (Page 77)

Example 3) Using cascade mode to add MTX input channels (analog connection)

MTX Setup Manual

Powering-on the MTX

Turn on the power of the MTX.

Turn off the amplifier before you power-off the MTX.

Powering-on the amp

On the rear panel of the XMV, set the [SPEAKERS] DIP switch, and then turn on the power of the amps (XMV).

To prevent unwanted sound from being output, we recommend that you turn down the attenuator settings of all channels on

the amp itself before you turn it on.

To change the XMV attenuator setting, press the button of the appropriate channel and then turn the encoder.

Specifying the computer’s TCP/IP address

To allow the MTX and the computer to communicate, specify the computer’s TCP/IP as follows.

On the [System] menu, click [Network Setup].

The “Network Setup” dialog box will appear.

Click [Open Network Connection].

“Network Connections” will appear.

Right-click the adapter to which the MTX is connected, and choose [Properties].

The “Local Area Connection Properties” dialog box will appear.

Choose [Internet Protocol Version 4 (TCP/IPv4)], and then click [Properties].

The “Internet Protocol Version 4 (TCP/IPv4) Properties” dialog box will appear.

Click [Use the following IP address (S)].

NOTE

• With the factory settings, the XMV’s attenuators are set to the lowest value.

• For more about the [SPEAKERS] DIP switch, refer to the XMV owner’s manual.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 128 129

No comments

Yamaha MTX3 User Manual Page 77