Yamaha MTX3 User Manual download pdf (Page 56)

Example 3) Using cascade mode to add MTX input channels (analog connection)

MTX Setup Manual

Set the [UNIT ID] rotary switch and DIP switch of the MTX and XMV.

You will set the computer’s IP address after completing the wizard, in “Specifying the computer’s TCP/IP address.”

If the MTX and XMV are not nearby, you can set them during the step “Connecting the equipment.”

Make the following settings.

When you have finished setting the [UNIT ID] rotary switch and DIP switch of the MTX and

the XMV, click [Next>].

MTX3

UNIT ID = 01

[UNIT ID] rotary switch = 1

DIP switches are all OFF (upward)

MTX3

UNIT ID = 02

[UNIT ID] rotary switch = 2

DIP switches are all OFF (upward)

XMV

UNIT ID = 1A

[UNIT ID] rotary switch = A

DIP switch 1 is ON (downward), others are OFF (upward)

NOTE

Use the DIP switch to specify the upper digit of the UNIT ID, and use the [UNIT ID] rotary switch to specify the lower digit. For

details, refer to the owner’s manual of each unit.

UNIT ID = 1 A

Lower digit: specify using the rotary switch

Upper digit: specify using DIP switch 1–3

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 128 129

No comments

Yamaha MTX3 User Manual Page 56