Yamaha S90 Manual download pdf (Page 73)

Basics SectionQuick GuideReferenceAppendix

Saving the Settings (Store)

You can store (save) your original parameter settings to

User Memory. The procedure is as follows.

When you perform this, the settings for the destination

data will be overwritten. Important data should always

be backed up to computer, a separate memory card or

some other storage device (page 82).

When changing the Name, refer to page 34.

n The edited Mixing data can be stored by using the Put

function (page 79).

1 Press the [STORE] button after editing a Voice/

Performance. The Store screen appears.

2 Use [DEC/NO] and [INC/YES] buttons to select the

destination program.

3 When you press the [ENTER] button, you will be

prompted for conﬁrmation.

n You can press the [DEC/NO] button to cancel the

Store operation and return to the original screen.

4 Press the [INC/YES] button to conﬁrm. When it

has been completed, a “Completed” message

appears, and operation returns to the original

screen.

Never attempt to turn off the power while data is being

written to Flash ROM (while an “Executing...” or

“Please keep power on” message is shown). Turning the

power off in this state results in loss of all user data and

may cause the system to freeze (due to corruption of data

in the Flash ROM).

Plug-in Voices

Up to three Plug-in boards can be installed to the

S90. If the Plug-in Board has been correctly

installed, the corresponding SLOT lamp will light.

The Plug-in voices can be edited via the S90’s panel

operation in much the same way as User voices.

After editing, up to 64 Plug-in voices for each Plug-

in slot can be stored.

Editing and saving Board voices

Included among the Board voices is a special set of

voices — called Board Custom voices — which can

be edited by a computer connected to the S90, using

special editing software included with the Plug-in

board.

Because the Plug-in boards do not have SRAM and

the edited voice data will be lost when turning the

power off, the edited Board Custom voice data

should be saved to a Memory Card inserted to the

S90. The Board Custom voice data saved to the

memory card can be loaded automatically when

turning the power on by using the Auto Load

function.

1 Edit the Board voice by using the Editor software.

2 Transmit the edited data to the memory

(DRAM) on the Plug-in board.

ex. Voice

Destination Program (Voice)

PROGRAM

SLOT 1 SLOT 2 SLOT 3

ORGAN BASS STRINGS BRASS REED/PIPEGUITAR/

PLUCKED

PRE 3 GM USER PLG 1 PLG 2 PLG 3

Comments to this Manuals

No comments

Yamaha S90 Manual Page 73

Comments to this Manuals