Yamaha V2 Owner's Manual download pdf (Page 30)

M7CL V2 Editor Owner’s Manual

G RATIO

Speciﬁes the ratio at which the input signal will be compressed when the key-in signal exceeds the threshold.

H KNEE

Speciﬁes the sharpness at which the output level will change. You can select from HARD or 1–5.

I ATTACK

Speciﬁes the time from when the key-in signal exceeds the threshold level until the signal starts being compressed.

J GAIN

Adjusts the gain of the signal after it has passed through the compressor.

K RELEASE

Speciﬁes the time from when the key-in signal falls below the threshold level until compression is removed.

L KEY IN SOURCE

Click this to select the key-in signal that you want to use.

The choices are the same as for GATE.

If COMPANDER-H, COMPANDER-S is selected

A TYPE

Indicates the type of the currently selected compressor. You can click here to select the type.

B LIBRARY

This button accesses the dynamics library. Clicking this button will open the DYNAMICS page of the LIBRARY

window.

C ON

This button switches the compressor on/off.

D Response curve

Indicates the response for the compander of the currently selected channel.

E GR meter

This meter indicates the amount of gain reduction produced by the compressor.

F THRESHOLD

Speciﬁes the threshold level at which the compressor will operate. The input signal will start being compressed

when the key-in signal exceeds this level; compression will be removed when the signal falls below this level.

G RATIO

Speciﬁes the ratio at which the input signal will be compressed when the key-in signal exceeds the threshold.

2 35

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 72 73

No comments

Yamaha V2 Owner's Manual Page 30