Yamaha V2 Owner's Manual download pdf (Page 41)

M7CL V2 Editor Owner’s Manual

❏ BALANCE (except for MONO channel)

This adjusts the left/right volume balance in the STEREO bus. You can set this to the center value by holding

down the <Ctrl> key of your computer keyboard and clicking this knob.

❏ EQUALIZER

This is the same as the equalizer settings of a MIX channel (➥ p.36).

❏ DYNAMICS1

Except for the fact that the available types are COMPRESSOR, EXPANDER, COMPAND H and COMPAND S,

and that you can select more than one signal as the key-in signal, this is the same as the dynamics for input chan-

nels (➥ p.28).

❏ INSERT

Except for the fact that the insert points that can be selected are different, this is the same as for the insert settings

of an input channel (➥ p.32).

❏ RECALL SAFE/MUTE SAFE

These are the same as the RECALL SAFE/MUTE SAFE of a MIX channel (➥ p.37).

❏ MUTE GROUP

These are the same as the MUTE GROUP of a MIX channel (➥ p.37).

❏ Fader

A ON

This switches the STEREO/MONO channel on/off. This is

linked with the STEREO/MONO MASTER section [ON]

keys on the M7CL’s panel.

B Fader

Adjusts the output level of the STEREO/MONO channel.

This is linked with the STEREO/MONO MASTER section

faders of the M7CL’s panel. A meter indicating the signal level

is shown at the right of the fader, and the current value is

shown in the numerical box immediately below.

CCUE

This button cue-monitors the signal of the STEREO/MONO

channel. This is linked with the STEREO/MONO MASTER

section [CUE] keys on the M7CL’s panel.

STEREO MONO

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 72 73

No comments

Yamaha V2 Owner's Manual Page 41