Yamaha V2 Owner's Manual download pdf (Page 38)

M7CL V2 Editor Owner’s Manual

If a MATRIX channel is selected

❏ CHANNEL SELECT (Channel selection)

Except for the fact that your editing applies to a MATRIX channel, this is the same as the channel selection for a

MIX channel (➥ p.34).

❏ FROM MIX, ST/MONO

A FROM MIX, ST/MONO send level

These adjust the send levels of the signals sent from the VARI type MIX buses or STEREO/MONO buses to the

MATRIX bus. The current value is shown in the numerical box immediately below.

• PRE/POST

These select either PRE or POST as the position from which the signal is sent from the MIX buses or STEREO/

MONO buses to the MATRIX bus. PRE POINT is selected if this is on, or POST FADER is selected if this is off.

B ON(FROM MIX, ST/MONO send on/off)

These are on/off switches for the signal sent from the MIX buses or STEREO/MONO buses to the MATRIX bus.

• If MIX buses and MATRIX buses are being used in stereo, the

odd-numbered knob will be PAN.

• If the FIXED type is selected for the MIX bus, only the ON but-

ton is valid.

• The stereo/mono setting and the VARI type / FIXED type setting can be made in the Mixer Setup screen.

HINT

PAN (odd-numbered side)

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 72 73

No comments

Yamaha V2 Owner's Manual Page 38