Yamaha V2 Owner's Manual download pdf (Page 35)

M7CL V2 Editor Owner’s Manual

• If you are using MATRIX buses in stereo, the knob for the odd-numbered bus will

be PAN.

• The stereo/mono status can be speciﬁed in the Mixer Setup screen.

❏ TO STEREO/MONO

Here you can specify how the signal will be sent from the MIX channel to the STEREO bus / MONO bus.

MODE

• ST/MONO button

When this button is on, the signal will be sent to the STEREO bus and independently to the MONO bus.

• LCR button

When this button is on, the signal will be sent to the L/C/R buses which work in conjunction with each other.

PAN

Adjusts the panning of the signal sent from the MIX channel to the STEREO bus L/R chan-

nels. You can set this to the center position by holding down the <Ctrl> key of the computer

keyboard and clicking the knob. This is linked with the [PAN] encoder in the SELECTED

CHANNEL section of the M7CL panel. If the selected MIX bus is used as a stereo bus, the

odd-numbered channel is ﬁxed at L63 and the even-numbered channel ﬁxed at R63.

ST Switches the signal sent from the MIX channel to the STEREO bus on/off.

MONO Switches the signal sent from the MIX channel to the MONO bus on/off.

BALANCE

This is shown only if the selected MIX bus is assigned as a stereo bus. It adjusts the left/

right volume balance of the stereo bus. You can set this to the center position by holding

down the <Ctrl> key of the computer keyboard and clicking the knob.

PAN

Adjusts the panning of the signal that is sent from the MIX channel to each of the L/C/R

channels. You can set this to the center position by holding down the <Ctrl> key of the com-

puter keyboard and clicking the knob. This is linked with the [PAN] encoder in the

SELECTED CHANNEL section of the M7CL panel. If the selected MIX bus is used as a ste-

reo bus, the odd-numbered channel is ﬁxed at L63 and the even-numbered channel ﬁxed at

R63.

BALANCE

This is shown only if the selected MIX bus is assigned as a stereo bus. It adjusts the left/

right volume balance of the stereo bus. You can set this to the center position by holding

down the <Ctrl> key of the computer keyboard and clicking the knob.

CSR (Center Side Ratio)

Adjusts the proportion of the CENTER channel level relative to the STEREO bus L/R in a

range of 0–100%.

HINT

Knob of odd-

numbered side

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 72 73

No comments

Yamaha V2 Owner's Manual Page 35