Yamaha V2 Owner's Manual download pdf (Page 25)

M7CL V2 Editor Owner’s Manual

❏ MIX/MATRIX SEND

A MIX send level

This adjusts the send level of the signal sent from the input channel to VARI-type MIX bus and MATRIX bus. The

current value is shown in the numerical box immediately below.

B PRE (Pre/Post)

This selects PRE or POST as the point from which the signal is sent from the input channel to the MIX bus and

MATRIX bus. The point will be PRE POINT when this is on, and POST FADER when this is off. The PRE POINT

setting can be speciﬁed in the Mixer Setup screen.

C ON (MIX send on/off)

This is an on/off switch for the signal sent from the input channel to the MIX bus and MATRIX bus.

• If MIX buses or MATRIX buses are being used in stereo, the

odd-numbered knob will be PAN.

• If the FIXED type is selected for the MIX bus, only the ON but-

ton is valid.

• The stereo/mono setting and the VARI type / FIXED type setting can be made in the Mixer Setup screen.

❏ HA GAIN/Ø/HPF

A HA (HA Gain)

Adjusts the gain of the internal head amp or of the external head amp (AD8HR) patched to the input channel.

The current value is shown in the numerical box below the knob. You can set this to the default value (+10 dB) by

holding down the <Ctrl> key and clicking the knob. You can also use the [48V] button to switch phantom power

on/off.

B Ø (Phase)

Inverts the phase of the signal after AD conversion.

C HPF (High Pass Filter)

Use the [ON] button at the right to switch the high-pass ﬁlter on/off. You can use the knob at left to adjust the

cutoff frequency. The current value is shown in the numerical box below the knob. An indication of “H” will

appear on the EQ graph of the equalizer.

HINT

Phace

Knob of odd-num-

bered side

1 32

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 72 73

No comments

Yamaha V2 Owner's Manual Page 25