Yamaha V2 Owner's Manual download pdf (Page 29)

M7CL V2 Editor Owner’s Manual

J HOLD

Speciﬁes the time that the gate will remain open after the key-in signal falls below the threshold.

K KEY IN SOURCE

Click this to select one of the following signals to use as the key-in source.

L CUE

This button cue-monitors the currently selected key-in signal. This is not shown in the ADDITIONAL VIEW.

M KEY IN FILTER

Select the type of ﬁlter applied to the selected key-in signal; HPF (high pass ﬁlter), BPF (band pass ﬁlter), or LPF

(low pass ﬁlter). The ON/OFF button switches the ﬁlter on/off.

If you’ve selected BPF, use the two knobs to adjust the band pass frequency and Q. If you’ve selected HPF or LPF,

use the knob to adjust the cutoff frequency.

If COMPRESSOR is selected

A TYPE

Indicates the type of the currently selected compressor.

B LIBRARY

This button accesses the dynamics library. Clicking this button will open the DYNAMICS page of the LIBRARY

window.

C ON

This button switches the compressor on/off.

D Response curve

Indicates the response for the compressor of the currently selected channel.

E GR meter

This meter indicates the amount of gain reduction produced by the compressor.

F THRESHOLD

Speciﬁes the threshold level at which the compressor will operate. The input signal will start being compressed

when the key-in signal exceeds this level; compression will be removed when the signal falls below this level.

SELF PRE EQ The pre-EQ signal of the currently selected input channel

SELF POST EQ The post-EQ signal of the currently selected input channel

MIX OUT 13–16

The output signal of the corresponding MIX channel immediately before the output

attenuation

CH 1–48 POST EQ The post-EQ signal of the corresponding input channel (however, you can only choose

channels belonging to the same group, within the seven groups CH1–8, CH9–16,

CH17–24, CH25–32, CH33–40, CH41–48, and STIN1L–STIN4R).

STIN1L–STIN4R POST EQ

2 3

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 72 73

No comments

Yamaha V2 Owner's Manual Page 29