Yamaha V2 Owner's Manual download pdf (Page 26)

M7CL V2 Editor Owner’s Manual

❏ TO STEREO/MONO

Here you can specify how the signal will be sent from the input channel to the STEREO bus / MONO bus.

MODE

• ST/MONO button

When this button is on, the signal will be sent to the STEREO L/R bus and independently to the MONO bus.

• LCR button

When this button is on, the signal will be sent to the L/C/R buses which work in conjunction with each other.

PAN (BALANCE for ST IN)

Adjusts the panning of the signal sent from the input channel to the STEREO bus L/R chan-

nels. You can set this to the center position by holding down the <Ctrl> key of the computer

keyboard and clicking the knob. This is linked with the [PAN] encoder in the SELECTED

CHANNEL section of the M7CL panel.

ST Switches the signal sent from the input channel to the STEREO bus on/off.

M(C) Switches the signal sent from the input channel to the MONO bus on/off.

PAN (BALANCE for ST IN)

Adjusts the panning of the signal that is sent from the input channel to each of the L/C/R

channels. You can set this to the center position by holding down the <Ctrl> key of the com-

puter keyboard and clicking the knob. This is linked with the [PAN] encoder in the

SELECTED CHANNEL section of the M7CL panel.

CSR (Center Side Ratio)

Adjusts the proportion of the CENTER channel level relative to the STEREO bus L/R in a

range of 0–100%.

[INPUT CH 1–48] [ST IN channel 1–4]

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 72 73

No comments

Yamaha V2 Owner's Manual Page 26