Yamaha V2 Owner's Manual download pdf (Page 56)

M7CL V2 Editor Owner’s Manual

J Output meter

Indicates the level of the signal being output from the internal effect.

K Parameter display select button

If “046 REV-X Hall,” “047 REV-X ROOM,” or “048 REV-X PLATE” is selected as the effect type, this button

switches between the standard parameter screen and a dedicated GUI screen.

L MIX BALANCE

Adjusts the balance of the effect sound relative to the original sound. 0 (%) outputs

only the original sound, and 100 (%) outputs only the effect sound.

M TEMPO

If a tempo-type or modulation-type effect is selected, this allows you to adjust time-

related parameters such as DELAY (delay time) and FREQ. (modulation speed).

To set the value of the TEMPO parameter, you can either input the BPM (Beats Per

Minute) in the numerical box, or repeatedly click the TAP TEMPO button at the

desired tempo.

If the MIDI CLK button is on, the TEMPO parameter value will synchronize to the

MIDI timing clock being received from the MIDI port.

N SOLO

If “044 M.BAND DYNA” or “045 M.BAND COMP” are selected as the effect type, these

buttons allow you to monitor only the speciﬁed band from the three bands HIGH,

MID, and LOW.

OGR meter

If “044 M.BAND DYNA” or “045 M.BAND COMP” are selected as the effect type, this

indicates the gain reduction amount for the H (HIGH), M (MID), and L (LOW) bands.

P PLAY/REC (Play/Record) buttons

If “042 FREEZE” is selected as the effect type, you can use these buttons to record and play back the signal being

input to the effect.

Q Effect parameters

This area shows the effect parameters and knobs for the currently selected effect type.

P Q

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 72 73

No comments

Yamaha V2 Owner's Manual Page 56