Yamaha F150 Service Manual Page 250

  • Download
  • Add to my manuals
  • Print
  • Page
    / 313
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 249
BRKT
Bracket unit
7-41
63P3F11
4. Install the trim piston assemblies into the
trim cylinders, and then tighten the trim
cylinder end screws to the specified
torque.
CAUTION:
Make sure that the trim rams are fully
extended when installing them.
Once installed, never push the trim rams
down, otherwise fluid can spurt out.
5. Install new O-rings, the valve pin, and
valve seat assembly onto the tilt cylinder.
NOTE:
Refer to the illustration for valve pin and
valve seat assembly installation.
6. Install the gear pump housing.
7. Install the O-ring into the reservoir cap.
8. Install the reservoir and O-ring onto the
gear pump housing.
9. Fill the tilt cylinder with the recommended
fluid to the correct level through the hole
e
as shown.
Trim and tilt wrench:
New: 90890-06587
Current: 90890-06548
T
R
.
.
Trim cylinder end screw:
78 N·m (7.8 kgf·m, 57.5 ft·lb)
S63P7040
S60X7720
T
R
.
.
Gear pump housing mounting bolt:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
T
R
.
.
Reservoir mounting bolt:
5 N·m (0.5 kgf·m, 3.7 ft·lb)
Recommended power trim and tilt
fluid:
ATF Dexron
II
S60X7730
S60X7400
Page view 249
1 2 ... 245 246 247 248 249 250 251 252 253 254 255 ... 312 313

Comments to this Manuals

No comments