
BRKT
Bracket unit
7-27
63P3F11
Removing the power trim and tilt unit
1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever
1
.
WARNING
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could sud-
denly lower if the power trim and tilt unit
should lose fluid pressure.
NOTE:
• If the power trim and tilt does not operate,
loosen the manual valve
2
and tilt the out-
board motor up manually.
• If the manual valve is loosened, be sure to
tighten it to the specified torque after tilting
the outboard motor up.
2. Remove the bolt and disconnect the
ground lead at the bottom of the power
trim and tilt unit.
3. Remove the plastic ties, and then pull out
the PTT motor leads.
4. Remove the bolts, then the lower mount-
ing shaft.
5. Remove the circlip, then the upper
mounting shaft.
T
R
.
.
Manual valve:
3 N·m (0.3 kgf·m, 2.2 ft·lb)
S60X3020
1
S60X7110
Comments to this Manuals