
POWR
Power unit
5-55
63P3F11
20. Before installing the oil filter, be sure to
fill it with engine oil through the oil pas-
sage
j
of the oil filter bracket.
21. Install the oil filter, and then tighten it to
the specified torque using a 72.5 mm
(2.9 in) oil filter wrench.
NOTE:
Apply a thin coat of engine oil to the O-ring of
the new oil filter before installation.
22. Install a new gasket and the exhaust
cover, and then tighten the bolts to the
specified torques in two stages and in the
sequence shown.
23. Install the thermostat
E
and cover
F
.
Installing the power unit
1. Clean the power unit mating surface, and
install the dowels
1
and a new gasket
2
.
2. Install the power unit
3
by installing the
bolts
4
and bolts
5
, then tightening
them to the specified torque.
3. Install the apron
6
, then tighten them to
the specified torque.
Oil filter wrench: 90890-06830
T
R
.
.
Oil filter:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
S63P5B20
j
Exhaust cover bolt:
1st: 6 N·m (0.6 kgf·m, 4.4 ft·lb)
2nd: 12 N·m (1.2 kgf·m, 8.9 ft·lb)
Thermostat cover bolt:
1st: 6 N·m (0.6 kgf·m, 4.4 ft·lb)
2nd: 12 N·m (1.2 kgf·m, 8.9 ft·lb)
S63P5C50
E
F
Comments to this Manuals