Yamaha AW2816 Owner's Manual download pdf (Page 263)

261

Reference section

Solo Setup page

Settings for the Solo function

Function

Here you can make various settings for

the Solo function.

Key operation

• [SETUP] key

→

[F5] (Solo Setup) key

• Repeatedly press the [SETUP] key

until the screen shown at the right

appears.

Screen functions

A STATUS

Use the following two buttons to select the operat-

ing mode in which the Solo function will be used.

• RECORDING SOLO button

When this button is on, the solo signal will be

routed through the dedicated SOLO bus and out-

put from the MONITOR OUT jacks/PHONES jack.

(It will not affect the signals sent to the stereo bus

or to buses 1–8.) You will also be able to monitor

channels that are not assigned to the stereo bus or

to buses 1–8.

This mode is convenient when you want to moni-

tor an input source during recording without

affecting the signals sent to the stereo bus or buses

1–8.

• MIXDOWN SOLO button

When this button is on, the solo signal will be

routed through the stereo bus and output from the

MONITOR OUT jacks/PHONES jack. When the

Solo function is turned on, only the soloed chan-

nel will be sent to the stereo bus, and other chan-

nels will be muted. For this reason, it is not

possible to monitor channels that are not assigned

to the stereo bus.

This mode is convenient when you want to solo a

speciﬁc channel during mixdown.

B LISTEN

When the RECORDING SOLO button is turned on

in the STATUS area (1), you can use the following

two buttons to select the location from which the

signal will be sent from each channel to the SOLO

bus.

• PRE FADER button

When this button is on, the signal from immedi-

ately before the fader will be sent to the SOLO

bus. Since the pan setting of each channel will

have no effect, the signal being monitored from

the MONITOR OUTPUT jacks/PHONES jack will

be monaural.

• AFTER PAN button

When this button is on, the signal that has passed

through the fader and pan will be sent to the

SOLO bus. The fader and pan settings will affect

the signal that is monitored in the MONITOR OUT

jacks/PHONES jack.

C SEL MODE (Select Mode)

When the Solo function is on ([SOLO] key lit), you

can use the following two buttons to choose how

the monitor signal will be selected.

• LAST SOLO button

When this button is on, only the channel whose

[ON] key was pressed last will be monitored.

• MIX SOLO button

When this button is on, you can use the [ON] keys

to select two or more channels for monitoring.

1 2 3 4

SETUP screen

1 2 ... 258 259 260 261 262 263 264 265 266 267 268 ... 419 420

Comments to this Manuals

No comments

Yamaha AW2816 Owner's Manual Page 263

Comments to this Manuals

Related products and manuals for Receiver Yamaha AW2816