EQ/ATT/GRP screen
300
Reference section
Fader Grp page
Assign/cancel fader groups
Function
Assign input channels 1–8 and monitor
channels 1–16 to fader groups A–D.
When you operate the fader of a chan-
nel that belongs to a fader group, all
channels belonging to that fader group
will be controlled together.
Key operation
• [EQ] key → [F3] (FaderGrp) key
• Repeatedly press the [EQ] key until
the screen shown at the right appears.
Screen functions
A Fader groups A–D
The ● symbols indicate the fader group A–D to
which each input channel 1–8 and monitor chan-
nel 1–16 belongs.
When you move the cursor up or down to select
group A–D and use the [SEL] key to select a chan-
nel, that channel will be assigned to the corre-
sponding fader group. When you press the [SEL]
key once again, the channel will be removed from
the fader group.
A channel cannot belong to more than one fader
group.
Tip!
While this page is displayed, the fader group assign-
ment status is also indicated by the lit/dark status of
the [SEL] keys.
B ENABLE
These buttons turn fader groups A–D on/off. The
A–D buttons will be highlighted to indicate that
the corresponding fader group is turned on.
Tip!
• If you want to adjust the fader location of a channel
after that channel has already been assigned to a
fader group, turn off the ENABLE button to tempo-
rarily defeat that fader group.
• If a screen other than the Fader Grp page is dis-
played, you can hold down the [SEL] key to tempo-
rarily exclude a channel from the fader group. By
operating the fader while you hold down the [SEL]
key, you can operate a desired channel indepen-
dently of the fader group.
Do not manually operate two or more faders of a
group at the same time. Doing so will strain the motor
and cause malfunctions.
■ Additional functions in the FaderGrp
page
In the FaderGrp page you can press the [SHIFT] key to
assign the following additional function to the [F1]
key.
• [F1] (ALL CLEAR) key
Cancels all fader group assignments.
2
1
Comments to this Manuals