Yamaha SREV1 Owner's Manual download pdf (Page 4)

Important Information

SREV1—Owner’s Manual

• Do not block the front panel air inlet, ventilation slots, or fan outlets. Doing so is a

potential ﬁre hazard.

Cautions

• Allow enough free space around the SREV1 for normal ventilation. This should be 20

cm behind, 10 cm at the sides, and 30 cm above. These distances should also be adopted

when rack-mounting the SREV1. If the SREV1 is mounted in a portable rack case, keep

the rear of the case open when using the SREV1 so as not to obstruct the ﬂow of air from

the two cooling fans. If the airﬂow is not adequate, the SREV1 will heat up inside and

may cause a ﬁre. Do not mount the SREV1 above equipment that produces a lot of heat,

such as a power ampliﬁer.

• Turn off all audio equipment when connecting to the unit, and use only cables of the

type speciﬁed in this

Owner’s Manual.

• If you plan not to use the unit for a long period of time, remove the power cord or AC

adapter from the AC outlet. Leaving the unit connected is a potential ﬁre hazard.

• Do not use benzene, thinner, cleaning detergent, or a chemical cloth to clean the unit.

Use only a soft, dry cloth.

• If the unit is stored in a cold place (e.g., overnight in a car), and then moved to a warmer

environment, or if the temperature rises sharply, condensation may form inside the

unit, which may affect performance. In this case, the unit should be allowed to acclima-

tize for about one hour before use.

• When the wordclock is changed on the wordclock master device, noise may occur from

the SREV1’s outputs, especially if an MY8-AT I/O card is installed, so turn down your

power amps beforehand, otherwise any connected speakers may be damaged.

• If the RC-SREV1 displays the message “LOW BATTERY” when you turn on the unit,

ask your Yamaha dealer to replace the internal battery as soon as possible. The unit will

still work, but data other than backed up data will be lost. We recommend that you save

this data to a PC Card before replacing the battery.

• For electrical safety reasons, it’s important that the SREV1 is grounded properly. The

supplied power cord has a three-pin plug, and if the ground terminal of the AC outlet

is grounded, then the SREV1 will be grounded sufﬁciently through the power cord. If

the AC outlet does not provide a suitable ground, however, a ground connection should

be made to the dedicated grounding screw.

1 2 3 4 5 6 7 8 9 ... 105 106

No comments

Yamaha SREV1 Owner's Manual Page 4