Yamaha SREV1 Owner's Manual download pdf (Page 43)

34 Chapter 4—Basic Operation

SREV1—Owner’s Manual

Selecting Reverb Modes

This section explains how to select the 2-channel, 4-channel, and 2-channel x2 Reverb

modes. See page 6 for more information about each mode.

1 Use the [UTILITY] button to locate the Setup page shown below.

2 Use the cursor buttons to select the 2CH, 4CH, or 2CHX2 button in the REV

MODE section of the page.

3 Press the [ENTER] button.

A conﬁrmation message appears.

4 Select YES to continue, or select NO to cancel the operation.

5 Press the [ENTER] button.

While the SREV1 switches to the selected Reverb mode, the RC-SREV1 displays the

message “SETTING REV MODE...” and the SREV1 INPUT and OUTPUT signal indi-

cators light up in sequence.

Once the mode has been set, the mode title appears in the Reverb mode section of the

display, the Program page is selected, and the cursor appears at the same position it does

when the power is turned on.

The SREV1 switches to the selected mode, the mode title appears in the Reverb mode

section of the display, and the Program page is selected.

The SREV1 stores all program parameters when the mode is changed, so when you

return to a mode, the previous settings are restored.

Note: Do not insert or eject a PC Card or CD-ROM while the SREV1 is changing Reverb

modes.

Reverb mode

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 105 106

No comments

Yamaha SREV1 Owner's Manual Page 43