Yamaha SREV1 Owner's Manual download pdf (Page 41)

32 Chapter 4—Basic Operation

SREV1—Owner’s Manual

SREV1 Startup

When the SREV1 is turned on, its INPUT and OUTPUT signal indicators light up in

sequence. During this time, the SREV1 loads impulse-response data for the current

program and the programs in Quick memory from the Internal Card, and, if necessary,

from the PC Card or CD-ROM. At this time, the SREV1 cannot be used. After about 30

seconds, when the necessary impulse-response data has been loaded, the CLIP and

SIGNAL indicators go out and the SREV1 is ready for use.

Note that the startup time will be different if the current program or the programs in

Quick memory are on PC Card or CD-ROM.

If the SREV1 does not output any sound, check your audio connections, and the input

assignments. See “Assigning Inputs” on page 35 for more information.

RC-SREV1 Startup

In Principle, the RC-SREV1 should be started up after the SREV1 has completed its

startup. However, when the RC-SREV1 is connected to one SREV1 using the supplied

remote cable, and that SREV1 is supplying power to the RC-SREV1, so long as the

RC-SREV1 POWER switch is set to the ON position, the RC-SREV1 will be turned on

at the same time as the SREV1 is turned on, and the RC-SREV1 will startup normally.

If, however, you are using multiple SREV1s, connected together using serial cables,

make sure that all SREV1s have completed startup before turning on the RC-SREV1.

When the RC-SREV1 is turned on, startup screen 1 appears for one second. Then star-

tup screen 2 appears with an animated waveform moving from left to right. During this

time, the RC-SREV1 receives necessary operating information from the SREV1 via the

serial cable. When all the information has been received, the Program page appears.

When the RC-SREV1 is turned on after the SREV1 has completed its startup, the above

procedure takes 15 seconds.

When the RC-SREV1 is turned on at the same time as the SREV1, it takes 45 seconds to

start up, although the actual time will depend on the time it takes the SREV1 to start up.

If there is no animation on startup screen 2, there may be a communication error

between the SREV1 and RC-SREV1. In this case, turn off both units and check the

remote cable connections, also check for breaks in the cable.

Startup screen 1 Startup screen 2

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 105 106

No comments

Yamaha SREV1 Owner's Manual Page 41