Yamaha SREV1 Owner's Manual download pdf (Page 63)

54 Chapter 5—Editing Programs

SREV1—Owner’s Manual

Main 2 Parameters

Basic parameters, including Reverb Balance, Input Level, Output Level, and Pre EQ

HPF frequency, can be adjusted on the Main 2 pages. In 2-channel x2 mode, two Main

2 pages are available: Main2-A and Main2-B. Channels are grouped, so adjusting, say,

the Reverb Balance parameter, adjusts the reverb balance of all channels simulta-

neously. In 2-channel x2 mode, A and B parameters are grouped independently. These

parameters can be adjusted for each channel individually on the Fine parameter pages.

See page 56 and page 57 for more information.

The graphs and parameter values of only one channel are displayed at a time. You can

choose which channel by using the buttons in the DISPLAY CHANNEL section of the

page. Below that section is the REV graph, which displays the reverb parameter settings

graphically, and the PRE-EQ graph, which displays the Pre EQ settings graphically. If

the EQ is turned off on the Pre EQ page (see page 57), the EQ graph appears shaded.

Likewise, if the HPF ﬁlter type parameter is set to THRU on the Pre EQ page, that also

appears shaded.

The Main 2 pages for each mode are shown below.

1 Use the [PARAMETER MAIN] button to locate the Main 2 page.

2 Use the cursor buttons to select a channel button in the DISPLAY CHANNEL

section, and then press the [ENTER] button to make it the active display chan-

nel.

The button of the active display channel appears highlighted.

3 Use the cursor buttons to select the REV BALANCE, INPUT LEVEL, OUTPUT

LEVEL, or HPF parameter.

4 Use the faders, DATA wheel, or [–1/DEC] and [+1/INC] buttons to adjust the

selected parameter.

2-ch mode

4-ch mode

2-ch x2 mode—A 2-ch x2 mode—B

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 105 106

No comments

Yamaha SREV1 Owner's Manual Page 63