Yamaha SREV1 Owner's Manual download pdf (Page 91)

Troubleshooting 85

SREV1—Owner’s Manual

Troubleshooting

Symptom Advice

Cannot turn on the

SREV1.

Make sure that the power cord is connected properly to a suitable AC wall outlet

and the SREV1. See “Connecting the Power Cord” on page 26 for more informa-

tion.

Make sure that the SREV1 POWER switch is set to ON. See “Turning On & Off the

SREV1” on page 26 for more information.

If you still cannot turn on the SREV1, contact your Yamaha dealer.

The POWER indicator

lights up when the SREV1

is turned on, but the

INPUT and OUTPUT

indicators ﬂash

alternately.

Contact your Yamaha dealer.

Cannot turn on the

RC-SREV1.

Make sure that the remote cable is connected between the SREV1 and RC-SREV1

properly. See “Connecting the RC-SREV1 Remote Controller” on page 22.

Make sure that the RC-SREV1 POWER switch is in the ON position. See “Turning

On & Off the RC-SREV1” on page 26 for more information.

The FS LOCK indicators

ﬂash alternately.

The SREV1 is locked but not synchronized to the external wordclock source. See

“Selecting the Wordclock Source” on page 75 for more information.

The FS LOCK indicators

ﬂash together.

The SREV1 is neither locked nor synchronized to the external wordclock source.

See “Selecting the Wordclock Source” on page 75 for more information.

The FS status section of

the RC-SREV1 display

shows “UNLOCK”.

The SREV1 is neither locked nor synchronized to the external wordclock source.

See “Selecting the Wordclock Source” on page 75 for more information.

Connected an input

signal but there’s no

output.

If you’re using slot inputs, make sure the I/O cards are installed properly and

secured using the thumbscrews. See “Installing I/O Cards” on page 84.

Make sure the input is assigned to the proper channel. See “Assigning Inputs” on

page 35 for more information.

Use the level meters to help trace the signal. See “Metering” on page 37 for

more information.

Check the channel’s input and output level settings. See “Setting Input & Output

Levels” on page 36 for more information.

Is the Bypass mode is set to REV-MUTE, the reverb balance set to 100%, and the

reverb level set to –∞?

Are you connected to the correct outputs? See “Output Assignments” on page 9

for more information.

Can’t hear any reverb.

Is the SREV1 bypassed. See “Bypassing the SREV1” on page 40 for more informa-

tion.

Make sure that the Reverb Balance parameter is not set to 0%. See “Main 2

Parameters” on page 54 and “Fine Reverb Parameters” on page 56 for more

information.

Make sure that the Reverb Level parameter is not set to 0 dB. See “Fine Reverb

Parameters” on page 56 for more information.

Recalled a program but

only its title is displayed,

no program number.

Probably because the program was recalled from a drive. Program numbers

(P01–P12) are displayed only when programs are recalled from the Quick memo-

ries. See “RC-SREV1 Display” on page 18 for more information.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 105 106

Comments to this Manuals

No comments

Yamaha SREV1 Owner's Manual Page 91

Comments to this Manuals