Yamaha SREV1 Owner's Manual download pdf (Page 65)

56 Chapter 5—Editing Programs

SREV1—Owner’s Manual

Fine Reverb Parameters

Reverb Time, Initial Delay, Reverb Balance, and Reverb Level parameters can be

adjusted for each channel individually on the Rev page, although there is an option to

group them. In addition to numeric values, settings are displayed graphically.

The Rev pages for each mode are shown below.

1 Use the [PARAMETER FINE] button to locate the Rev page.

Use the ON/OFF button in the GROUP section to group and ungroup the channels.

When set to ON, all channels are adjusted simultaneously. When set to OFF, channels

can be adjusted individually.

2 Use the cursor buttons to select the REV TIME, INITIAL DELAY, REV BALANCE,

or REV LEVEL parameter.

3 Use the faders, DATA wheel, or [–1/DEC] and [+1/INC] buttons to adjust the

selected parameter.

Note that since adjustments to the REV TIME parameter do not take effect immedi-

ately, there is a small delay between adjusting the reverb time by using, for example, a

fader and the new reverb time being applied, especially when channels are grouped.

The parameter ranges are as follows.

Parameter Range Steps Description

REV TIME

0.3–

1. Actual maximum reverb time depends on the impulse-response data.

0.1 sec Reverb time

INITIAL DELAY

0.1–500.0 ms 0.1 ms Delay before reverb starts

REV BALANCE

0–100% 1%

Balance between reverb and dry

signals. 0% = all dry, 100% = all

reverb.

REV LEVEL

–∞, –72 dB to +6.0 dB 0.1 dB Reverb level

2-ch mode 4-ch mode

2-ch x2 mode

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 105 106

No comments

Yamaha SREV1 Owner's Manual Page 65