Yamaha SREV1 Owner's Manual download pdf (Page 74)

Multiple-unit Operating Notes 65

SREV1—Owner’s Manual

Multiple-unit Operating Notes

• The RC-SREV1 should be connected to SREV1 #1.

• Connect the SREV1s together by using serial cables.

• Turn on the SREV1s ﬁrst, and then the RC-SREV1.

• Do not connect or disconnect any serial cables while the system is up and running.

• Do not turn off any of the SREV1s while the system is up and running.

Selecting SREV1s from the RC-SREV1

This section explains how to select the SREV1 to be controlled from the RC-SREV1.

1 Use the [UTILITY] button to locate the Setup page shown below.

2 Use the cursor buttons to select the SREV #1, SREV #2, SREV #3, or SREV #4

button in the CONNECT section of the page.

The button of the currently selected SREV1 appears highlighted. The buttons of uncon-

nected SREV1s appear shaded.

3 Press the [ENTER] button.

A conﬁrmation message appears.

4 Select YES to continue, or select NO to cancel the operation.

5 Press the [ENTER] button.

The RC-SREV1 retrieves system information such as Reverb mode, and wordclock

source from the selected SREV1, and then updates its display. The number of the

selected SREV1 appears in the top-right corner of the display (see page 18).

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 105 106

No comments

Yamaha SREV1 Owner's Manual Page 74