Yamaha SREV1 Owner's Manual download pdf (Page 37)

Using an Optional RC-SREV1 AC Adapter 27

SREV1—Owner’s Manual

Using an Optional RC-SREV1 AC Adapter

The remote cable, which carries power from the SREV1 to the RC-SREV1, is 20 meters

in length. Since the power loss in longer cables would be too great, an optional Yamaha

PA-6 AC power supply adapter (12 V DC) is required to power the RC-SREV1 when

using remote cables over 20 meters in length. A wiring diagram for making custom

remote cables is available on page 91. See your Yamaha dealer for more information.

The optional Yamaha PA-6 AC power supply adapter should be con-

nected to the DC 12V IN connector on the rear of the RC-SREV1.

Loop the AC adapter cable around cable clip,

shown here, to prevent accidental disconnection.

Adjusting the RC-SREV1 Brightness & Contrast

Both the brightness and contrast of the RC-SREV1 display can

be adjusted to suit your working environment or personal

preference.

1 Use the CONT control to set the display contrast.

Contrast adjusts the balance between pixels that are on and

those that are off.

2 Use the BRIGHT control to set the display brightness.

Brightness adjusts the strength of the display’s backlight.

Warning: Use only the Yamaha PA-6 AC power

supply adapter with the RC-SREV1. Using any

other AC adapter may cause a fault, leading to a

buildup of heat, ﬁre, or an electrical shock hazard.

DC 12V IN

BRIGHT CONT

LCD

REMOTEDC 12V INPOWER

ON OFF

12V IN

BRIGHT CONT

LCD

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 105 106

No comments

Yamaha SREV1 Owner's Manual Page 37