Matrix send shortcuts
83
■ Each MIX channel → single MATRIX
bus
In the MATRIX OUTPUT block of the panel, press and
hold the [SEL] switch of the MATRIX channel that is
sending the signal.
After you have held down the [SEL] switch for a time,
the MIX OUTPUT block MIX [NAME] indicator will
alternately display “SEND” and the short name of the
MIX channel.
While you continue to hold down the switch, use the
MIX OUTPUT block MIX [LEVEL/BAL] encoders to
adjust the send level or pan from each MIX channel to
the selected MATRIX bus. (The send level value is shown
by the LEDs surrounding the MIX [LEVEL/BAL]
encoder.)
In the case of a paired MATRIX channel, pressing the
[SEL] switch of the odd-numbered channel will cause
the [NAME] indicator of the MIX channel to alternately
display “PAN” and the short name, allowing you to set
the pan.
Pressing the [SEL] switch of the even-numbered channel
will cause the [NAME] indicator of the MIX channel to
display “SEND,” allowing you to set the send level.
This shortcut cannot be used in the STEREO OUT-
PUT block.
MATRIX OUTPUT
block
SEND SEND
PAIR
ON ON
Alternately displays “SEND”
and the short name of MIX
channel 1.
Alternately displays “SEND”
and the short name of MIX
channel 2.
Use this knob to adjust the send
level of the signal that is sent from
MIX channel 1 to MATRIX bus 1.
Indicates the send level of the
signal that is sent from MIX
channel 1 to MATRIX bus 1.
Use this knob to adjust the send
level of the signal that is sent from
MIX channel 2 to MATRIX bus 1.
Indicates the send level of the
signal that is sent from MIX
channel 2 to MATRIX bus 1.
MIX OUTPUT block
Comments to this Manuals