Yamaha 2100E - CRW - CD-RW Drive User Manual download pdf (Page 41)

2. Unzip the BIOS firmware and write the file “cdxxxx.bin”

or “dvdxxxx.bin” into the root directory on a blank

CD/DVD disc. Session of the CD/DVD has to be closed. If

the same disc still has capacity to add data, it can be

used to store newer version of BIOS program. When

updating BIOS program from the data disc, only the one

in last session will be used. Other versions in previous

sessions will be ignored.

6.15 Reset

The reset procedure is required for several reasons such as:

First assembling of duplicator, changing new brand of

writers in old duplicator, reset with wrong way or bring back

the factory default setting according to different usages. Our

design provides an easy way for customer to reset their

controller cards as below:

1. Turn off the power of duplicator and wait for 10 seconds.

If the duplicator is not used at this moment, ignore this

step and go to procedure 2 directly.

2. Press and hold down the MODE switch and turn on the

power of duplicator simultaneously (the MODE switch

must be held down at least 3 seconds while turning on

the power of duplicator).

3. Release the MODE switch after the message of “clear

setup” is shown on the top line of LCD display.

4. If the “clear setup” message is not shown, please repeat

the whole procedure above but remain the finger on

MODE switch all the time during power on till you see the

message of “clear setup” on LCD display.

5. All setting on duplicator will be restored to its factory

default setting after the “clear setup” message shown on

the LCD display, which is a correct reset procedure.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48 49

No comments

Yamaha 2100E - CRW - CD-RW Drive User Manual Page 41