Yamaha 2100E - CRW - CD-RW Drive User Manual download pdf (Page 31)

40GB hard drive installed with the controller card, you

might have 42 partitions from AA to AZ and BA to BP.

There will be two groups in your hard drive: A group

contains 26 partitions and B group contains 16. The entire

configuration will be done automatically and you don’t

have to run special software utility to make these

partitioning. Be noted that this setting will disappear if there

is no hard drive installed.

6.1.21 HD to CD Write Speed (if HDD installed)

This setting controls the maximum CD/DVD writing speed

of writers when the hard drive is installed in the system.

Default setting is “MAX” which will use the highest CD

writing speed. Sometimes maximum writing speed will

cause higher failure rate that may be due to poor CD/DVD

quality or unstable CD/DVD writing in high speed. Under

this circumstance, please lower the writing speed under

this setting to get higher successful rate. On the contrary,

lower value setting will make the writing speed slower and

confuse you as a problematic duplicator. Press MODE to

change the setting and GO to exit.

6.1.22 Load Nonblank Disc (if HDD installed)

This setting is mainly for Autoloader and controls the

loading of non-blank disc in any writer. If setting is “Yes”,

whenever there is a non-blank disc detected by the writer,

the duplicator will go to “Load” function automatically and

start loading the data from that non-blank disc into current

partition of hard drive. Through this function, you can

control the Autoloader to copy multi-master discs fully

automated. Press MODE to change setting and GO to exit.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 48 49

No comments

Yamaha 2100E - CRW - CD-RW Drive User Manual Page 31