Yamaha 2100E - CRW - CD-RW Drive User Manual download pdf (Page 16)

AA. With hard drive installed

a. Duplicator will automatically detect the hard drive and

create partitions for it (each partition will have 900MB

capacity for CD duplicator, e.g. 40 GB Hard Disk will

probably have 38 partitions. For DVD duplicator, 5GB for

each partition.)

b. You can select partition in the “hdd partition group”

function in Setup Menu.

c. If there is no data stored in present / selected partition of

hard drive, press the MODE switch to select “Load”

function and place the master disc into the

CD/DVD-ROM drive which will automatically detect the

master, analyze and load data into the present / selected

partition. The master disc will be ejected when loading is

completed. In case of error, the LCD will show “error”

and the master disc will also be ejected automatically.

Change another master disc for loading. Master data can

be stored in different partition, switch to that particular

partition (Please refer to hdd partition group) for loading.

d. Switch to Copy by pressing MODE switch. Place blank

CD/DVD discs into all the writers. Duplicator will start

copying when all writers detect the discs. If you do not

need to use all writers for copying, the LCD display will

display the number of CD disc detected as “ Xstart” (X

represents the number of writers with detected discs that

are ready to copy). Press the GO switch and operation

will start instantly. There is no limitation on number of

discs to be copied in one round (Vary on different model,

CD-398/DVD-3000 will be 9 pcs. in maximum targets.

For DVD-299 controller card, there will be three targets

in maximum.) or there is any limitation on sequence of

writer to start with. In other words, you may copy one

disc only using any one of the writers randomly.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 48 49

No comments

Yamaha 2100E - CRW - CD-RW Drive User Manual Page 16