Yamaha 2100E - CRW - CD-RW Drive User Manual download pdf (Page 17)

e. When Copy is completed on all writers, those discs

passed will be ejected automatically (default setting:

Passed discs will be ejected but this can be changed

according to your need). For continuous duplication,

place additional blank discs into the writers and repeat

the above procedures.

f. Failed disc(s) will remain in respective writer(s) (Default

setting: Failed discs will NOT be ejected but this can be

changed according to your need). Press MODE switch

will eject those failed discs from writers or press each

eject button on the writer to eject disc manually.

g. The duplicator will prompt you an error message when

you try to copy a partition that contains no data. In this

case, switch to “Load” function to load data first.

h. Do not press any switch during operation as interruption /

termination of operation will cause error and might cause

the duplicator to hang up (depend on writers installed).

The write-once discs during operation will be ruined and

might not be used again.

BB. Without hard drive

a. Switch to Copy by pressing MODE switch. Put blank discs

into all writers and duplicator will start copying when all

writers detect the discs. If you do not need to use all

writers for copying, the LCD display will display the

number of disc detected as “ Xstart” (X represents the

number of writer with detected discs that are ready to

copy). Press the GO switch and operation will start

instantly. There is no imitation on number of disc to be

copied in one round (Vary on different model, CD-398 /

DVD-3000 will be 9 pcs. in maximum targets. For

DVD-299 controller card, there will be three targets in

maximum. For CD-129 and DVD-299 one to one

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 48 49

No comments

Yamaha 2100E - CRW - CD-RW Drive User Manual Page 17