CONNECTIONS
Setting up the speaker parameters automatically (YPAO)
En 45
8
Replace the optimizer microphone at your
choosing position and press iENTER to
restart the automatic measurement.
Auto measurement restarts in 10 seconds.
Repeat step 8 until the measurement at all listening
positions are made.
The calculation based on result of measurement starts
when measurement at the last position finishes without
any problem.
When “Angle” is set to “No” in step 6
The following display appears when the calculation
finishes without any problems.
Go to step 14.
When “Angle” is set to “Yes” in step 6
The following display appears when the calculation
finishes without any problems.
Go to step 9.
9
Press iCursor D / E to select “YES” and
press iENTER.
The following display appears.
ENTER
R
E
ECEIVE
DI
-A
B
LTI
ET
H
N
D
K
A
B
i
The following illustration shows how to place the
optimizer microphone to optimize the setup of this
unit for eight listening positions for example. Up to 8
listening positions can be measured. J1
6
8
7
4 5
12 3
Save/Exit
Measure.Finish
YPAO
VOLUME
>YesNo
AngleMeasure?
YPAO
VOLUME
ENTERtoStart
Angle:Point1
YPAO
VOLUME
Continues to the
next page
J
1 : Measure from the most frequent listening position, such as
directly in front of the TV, first.
Comments to this Manuals