Yamaha MTX3 Manual download pdf (Page 184)

List of settings in “Settings” dialog boxes Appendix

MTX Editor User’s Manual

184

❍ [Parameter Range]/[Nominal]/[Knob]

Enable you to make a setting for the knob that has been specified in the [Assign the

send level to:] box. For details about the settings, refer to If [FUNCTION] is [Level]

for knobs/sliders.

● If [FUNCTION] is [Source Select w/sw] (DCP only)

You can control the send on/off for multiple channels via switches, and the send level

for any channel via switches.

If you assign the same source to multiple DCP units and then change the settings on

one of the DCP units, the changes will not be updated on other DCP units. Each DCP

unit will retain the settings (LED status and knob assignments) that were made on it.

❍ [MTX]

Selects the MTX for which you want to change the settings. These are listed in order

of UNIT ID and model name.

❍ [PARAMETER1]/[PARAMETER2]

In the [PARAMETER1] column, select the target ZONE.

In the [PARAMETER2] column, click ? to the left of the channel name to select ON,

OFF, or IGNORE for the desired channels. The ON/OFF/IGNORE setting can be

applied to multiple channels simultaneously. If you select an ON channel, the

bottom half of the dialog box will display the switch-related setting items.

❍ [Assign the send level to:] box

Enables you to assign a function that raises or lowers the send level of the selected

channels to other switches.

❍ [Inc]/[Dec]/[Switch]

Enable you to make settings for the switches specified in the [Assign the send level

to:] box. For details about the settings, refer to If [FUNCTION] is [Send Level Inc/

Dec] for switches.

NOTE

1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 200 201

No comments

Yamaha MTX3 Manual Page 184