Yamaha MTX3 Manual download pdf (Page 183)

List of settings in “Settings” dialog boxes Appendix

MTX Editor User’s Manual

183

❍ [Dec]

If you select this option, pressing the switch repeatedly will lower the level or the

send level.

✦[Lower Limit]

Specifies the minimum level to be achieved when you press the switch.

✦[Mute Enable] check box

If this option is selected, the Mute state (–∞ dB) will be enabled if the level is lowered

below the value specified by [Lower Limit].

❍ [Switch]

Allows you to make switch-related settings.

[Sensitivity] specifies the point at which the parameter will change when the switch

is pressed.

● If [FUNCTION] is [Source Select w/knob] (only for a DCP that

features knobs)

You can control the send on/off for multiple channels via switches, and control the send

level for any channel via knobs.

If you assign the same source to multiple DCP units and then change the settings on

one of the DCP units, the changes will not be updated on other DCP units. Each DCP

unit will retain the settings (LED status and knob assignments) that were made on it.

❍ [MTX]

Selects the MTX that you want to change. These are listed in order of UNIT ID and

model name.

❍ [PARAMETER1]/[PARAMETER2]

In the [PARAMETER1] column, select the target ZONE.

In the [PARAMETER2] column, click ? to the left of the channel name to select ON,

OFF, or IGNORE for the desired channels. The ON/OFF/IGNORE setting can be

applied to multiple channels simultaneously. If you select an ON channel, the

bottom half of the dialog box will display parameter fields related to the knobs.

❍ [Assign the send level to:] box

Enables you to select a knob that will control the send level of the currently-selected

channel.

Only one channel can be assigned to a knob.

NOTE

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 200 201

No comments

Yamaha MTX3 Manual Page 183