Yamaha MTX3 Manual download pdf (Page 164)

“Digital Control Panel” dialog box Chapter 7. Dialog boxes

MTX Editor User’s Manual

164

❑ “Digital Control Panel” dialog box

Here you can assign the MTX’s parameters to the controls of a digital control panel (DCP) such as

the DCP1V4S so that they can be operated from the DCP. You can also make settings for the

brightness of the DCP unit’s LEDs, as well as panel lock settings. You can’t make settings while

online. (Settings can only be viewed.)

You can store 32 sets of DCP settings in the Library. You can also associate library items with presets

for recall.

After editing in the [Parameter Assign] tab and the [Dimmer & Lock] tab, click the item in the

[Library] list to which you want to store, and then click the [Store] button to store the item to the

library.

In the [Library] list, click the library item that you want to recall, and then click the [Recall] button

to recall the library item; the settings will be applied to the [Parameter Assign] tab and the [Dimmer

& Lock] tab.

• If you associate a saved library item with a preset, the parameter assignments for all DCP

units (up to 32 units) connected to the MTX system will be recalled/stored in a single action

when you recall that preset. If you want to recall only a specific DCP, open the “Preset”

dialog box and make [Recall Filter] settings.

• You must use the “Device Configuration Wizard” dialog box to assign the MTX and DCP

units and specify their ID settings beforehand. If you have not made these settings yet, you

won’t be able to open the “Digital Control Panel” dialog box; an alert will be displayed.

● MTX selection box

Selects the MTX to which the target DCP unit is connected. The box will list units in

order of UNIT ID, followed by the name of the MTX.

● DCP selection box

Select the DCP unit for which you want to make settings. All DCP units that are

connected to the MTX (which is selected in the MTX selection box) are listed in order

of UNIT ID and the name of the DCP unit.

The model and graphic for the selected DCP are shown below the DCP selection box.

The control selected in the [Parameter Assign] tab will be highlighted.

NOTE

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 200 201

No comments

Yamaha MTX3 Manual Page 164