Yamaha R-N803 Owner's Manual download pdf (Page 17)

11 En

Connections

English

PREPARATION

Note

• Do not bundle audio cables and speaker cables together with the

power cable. Doing so may generate noise.

• The PHONO jacks are designed for connecting a turntable with

an MM cartridge.

• Connect your turntable to the GND terminal to reduce noise in

the signal. However, for some turntables, you may hear less

noise without the GND connection.

• If you have a Yamaha subwoofer that supports a system

connection, you can switch the power of the subwoofer in

conjunction with tuning on/off this unit by connecting the

subwoofer to the TRIGGER OUT jack with a monaural mini-

plug cable.

• In order to prevent the audio signal from looping when an audio

recording device is connected, the audio signal is not output

from the LINE 2 (OUT) jacks when LINE 2 is selected.

Similarly, the audio signal is not output from the LINE 3 (OUT)

jacks when LINE 3 is selected.

Connecting the speakers

CAUTION

Connect the speakers with impedance as shown below. If you

connect speakers with an excessively low impedance, this unit

may overheat. You can change the speaker impedance setting of

this unit in “SP. IMP” (p. 52) in the ADVANCED SETUP menu.

■ Connecting speaker cables

Speaker cables have two wires. One is for connecting the

negative (–) terminal of the unit and the speaker, and the

other is for the positive (+) terminal. If the wires are

colored to prevent confusion, connect the black wire to the

negative and the other wire to the positive terminal.

Remove approximately 10 mm (3/8”) of insulation from the ends of

the speaker cable and twist the bare wires of the cable firmly together.

b Loosen the speaker terminal.

c Insert the bare wires of the cable into the gap on the side (upper

right or bottom left) of the terminal.

d Tighten the terminal.

Note

When inserting speaker cables into the speaker terminals, insert

only the bare speaker wire. If insulated cable is inserted, the

connection may be poor and sound may not be heard.

■ Connecting via banana plug

(North America, Australia,

General models only)

Tighten the knob and then insert the banana plug into the

end of the corresponding terminal.

Speaker connection

Speaker impedance (SP IMP.)

4 MIN

8 MIN

(Default)

SPEAKERS A or

SPEAKERS B

4 Ω or higher 8 Ω or higher

SPEAKERS A and

SPEAKERS B

8 Ω or higher 16 Ω or higher

Bi-wire connection 4 Ω or higher 8 Ω or higher

10 mm

(3/8")

Banana plug

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 215 216

Comments to this Manuals

No comments

Yamaha R-N803 Owner's Manual Page 17

Comments to this Manuals

Related products and manuals for Car media receivers Yamaha R-N803