Yamaha ROADLINER XV19SC Installation Manual download pdf (Page 23)

LEGUP LITE - ADDENDUM

If you have a Lite System, there are a few differences in the wiring compared to our Regular

system.

The plugs and their locations don’t change at all! Instead of plugging in the computer to the

twelve pin plug, the Relay-Pack gets plugged into this plug. The Relay-Pack will be attached

with Velcro as the computer would have been in the same location.

On the LITE system there is no proximity sensor, so ignore the testing and mounting of this

sensor, and realize that the three pin plug will be left without a mating connector. We keep this

plug in the wiring harness in case you upgrade to a regular system in the future.

Using Your Lite System:

Unlike our Regular System, you don’t turn the LITE system on, or adjust the legs as described

in the ‘Maintenance Mode’ section of the manual. When you turn your bike on, the LITE

system is ready to go! Press and hold the left button to lower the wheels, press and hold the

right button to raise them. No lights will flash; it is up to you to control the system manually!

Please use EXTREME Caution when using the LITE System! Keeping the

wheels lowered at speeds over 9MPH can be dangerous. Since the system is

manual, please don’t allow its’ operation to distract you from controlling the

vehicle!

Upgrading Your LITE System:

If you have a LITE System and have chosen to upgrade it to the regular system, there are just a

few things you need to do. Unplug the Relay-Pack, and plug the computer in where the Relay-

Pack was attached. Run the wire for the proximity bracket and plug it in, test it, and mount it, as

described in the ‘MOUNT PROXIMITY SWITCH’ section of this manual.

Once the new pieces are attached and plugged in, refer to

‘

ACTUATOR ADJUSTMENT

(Maintenance Mode)’, earlier in this manual to set the lower and upper stops for the computer.

That’s all it takes!

1 2 ... 18 19 20 21 22 23 24 25 26

No comments

Yamaha ROADLINER XV19SC Installation Manual Page 23