Yamaha ROADLINER XV19SC Installation Manual download pdf (Page 14)

WIRING HARNESS

NOTE: If you have a LITE System, Please refer to the addendum at the end of this manual,

for differences between a Regular and LITE Harness!

The next step is to route the wiring harness. The harness and the plugs are routed mostly under

the seat area cover. We already ran the wires from the handlebar switch and the speed sensor.

The actuator wire should be run under the seat area behind the fender support (self-adhesive

straps are included to secure wire away

from swing-arm and belt). Make sure to

leave enough slack in the wire to allow

the actuator to lower the legs completely

without tugging on the wire here.

Now take the harness and find the 12-

place plug. This needs to be routed near

the saddlebag from the seat area Picture

left… notice the grey wire which is the

actuator plug plugged together already!).

The rest of the harness should have

mating plugs waiting under the seat for

them. Find each plugs mate, they only

plug in one way, and plug them together.

The Proximity sensor is not mounted yet

because we need to have power to make sure it

is placed perfectly, so just route the wire for

now. You can collect any excess wire under

the side cover when the time comes.

Next we need power for the system. There is a

black box looking thing with lots of wires that

can be lifted. Beneath it lays a Yellow plug.

Find the blue wire connected to it and install

the crimp plug supplied around this wire. Close

the plug and use pliers to click it closed. This

makes a female spade plug (picture at right).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

No comments

Yamaha ROADLINER XV19SC Installation Manual Page 14