Yamaha ROADLINER XV19SC Installation Manual download pdf (Page 21)

TEST RIDE

NOTE: If you have a LITE System, Please refer to the addendum at the end of this manual,

for differences between a Regular and LITE system. Deployment and Retraction of the

wheels is COMPLETELY MANUAL if you have a LITE System.

Get the bike to a clear paved mostly level area where you can test ride it. Start the bike, turn on

the LegUp system and lower the legs. The first test should be done in a straight line. Put the

bike in gear and slowly accelerate. You may notice that the bike tends to want to steer a small

amount left or right. This is normal unless it is severe. Once underway, the top LED should

flash at around 6 MPH, meaning the legs are retracting. You can lean on one wheel or the other

as you leave to reduce any darting the system may be giving you.

Assuming the legs are retracted, you should try to deploy the wheels. As you come to a stop,

the Green LED should be on. As you slow down (almost stopped), the Yellow LED should

illuminate at the proper speed. Once it does (sometimes hard to see), hit the left button and put

your feet down near the ground. The top LED should flash and you should soon feel the wheels

deploying underneath you! Make sure you are ready to balance the bike! Uneven ground or

lack of familiarity could make the bike want to lean one way or the other. With your feet ready

to balance the bike, this should be no big deal. The slower you are going when deploying the

wheels, the smoother the transition will be from wheels up to wheels down. Practice these

maneuvers until you are comfortable with the wheel adjustments and the system operation.

SEMI-AUTOMATIC DEPLOYMENT: Another way to deploy the legs is to hit the left button

while you are running at any speed over 10MPH with the wheels up. The bottom or yellow

LED should start to flash. When you slow down to around 8MPH the wheels will start to deploy

(see the red/green flash on top LED). Again prepare to put your feet down.

NOTE: The bottom LED Should not be LIT if the legs are up over 10MPH! In

the event it is, the wheels will deploy instantly if you try to set them as above; this

is dangerous! You MUST re-visit the sections on testing the proximity sensor.

You should always be aware that this light should NOT be on if you are traveling

at speed, and ‘Arming’ the system for deployment should only be attempted if the

lower LED is Not Lit! Please see the User Manual for more information on

Proximity Sensor Failure!

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

No comments

Yamaha ROADLINER XV19SC Installation Manual Page 21