Yamaha ROADLINER XV19SC Installation Manual download pdf (Page 16)

INITIAL SYSTEM TEST

NOTE: If you have a LITE System, Please refer to the addendum at the end of this manual,

for differences between a Regular and LITE system. Skip this section if you have a LITE

System.

Turn your key switch on. At this point, have a look at the yellow proximity sensor (it should be

dangling near the front forks somewhere). The LED Should Not Be Lit. Take a metal object

(screwdriver, wrench, etc) and hold it on the flat face of the sensor (it has a circle embossed in

it). The LED should light up, and go out when you move the metal away. If not, check all your

connections.

Next, press the rightmost pushbutton on the switchbox, and hold it for at least 3 seconds. One or

both LEDs on the switch panel should light up; we really don’t care which at this point. If this

occurs, you are doing well. If both LEDs are flashing (maintenance mode) you can skip the

next step which is to press both buttons until both LEDs flash.

Next press both buttons for just an instant! If everything is working, the bottom or yellow LED

on the switch box should flash, and the top LED should be out. The next step, and be careful

here, is to touch the left button for a split second. The legs should move down just a bit. Touch

the right button, and they should move up. With the bike on the lift,

you have to be very

careful here!

If all of the above has occurred, raise the legs. Press and hold the right button until it or is as

high as you wish, and turn the ignition switch off!

The test is now complete. Let’s move on to mounting the Proximity Sensor.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

No comments

Yamaha ROADLINER XV19SC Installation Manual Page 16