Yamaha ROADLINER XV19SC Installation Manual download pdf (Page 19)

WIRE ROUTING

NOTE: If you have a LITE System, Please refer to the addendum at the end of this manual,

for differences between a Regular and LITE system.

Guide the wires from the Proximity bracket up

the brake line, and attach it to the line with

wire ties. Once routed, make sure both this

wire and the wires from the handlebars are

secure and allow full lock of the handlebars

both left & right! Take whatever extra slack

from the two wires that is available, and pull it

back to the seat area!

Unplug the Computer Enclosure from the

harness, and using the Velcro, attach the

enclosure with the wires facing down. Once

the enclosure is attached, make sure closing

the bag does not crush this wire. Use the self

adhesive wire holder to guide the wire up and out of the bag as you see fit. Now pull any

excess wire back in under the seat.

Use wire ties to make sure that all

wires will stay where you put them

and that they will not come on

contact with the belt or anything

else that moves Keep the excess

wire clean and make sure the seat

goes on and off without hitting any

wires.

With help, support the bike and turn

on the LegUp system (see owners

manual). It should start in

maintenance mode, but if it doesn’t,

please enter maintenance mode

(again in the manual). Now

carefully, lower and raise the legs

and make sure the wires are not binding and that they clear everything! Raise the legs most of

the way and turn off the bike. Now we are ready to button everything up.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26

No comments

Yamaha ROADLINER XV19SC Installation Manual Page 19