Yamaha ROADLINER XV19SC Installation Manual download pdf (Page 13)

CONTROL SWITCH BOX

NOTE: If you have a LITE System, Please refer to the addendum at the end of this manual,

for differences between a Regular and LITE system. The LITE System does NOT have a

Proximity Sensor! Ignore all references to the Proximity Sensor, Its’ mount & wiring.

Disassemble the 8-pin connector attaché to the switch housing and the 3

pin connector attached to the speed sensor (yellow on a black bracket).

Because the wire run to the seat area is so long on this bike, we want to

run both of these wires to the seat area, reassemble the plugs and then

mount the switch housing. Run the wire from the speed sensor bracket

up to the tank area to join the switch wires. See the pictures below and

run the wires for the switch housing from in front of the handlebar,

down in front of the top triple tree and then join

the other wire and run them BOTH around and

under the left side of the tank to the seat area.

Take all the slack you need so you can easily

reassemble these plugs (wire diagrams: switch

top left, speed sensor bottom right) under the

seat area (below, left). Then you can pull the

excess slack back to install the Handlebar control

& the speed sensor bracket.

Find the long black bolt and spacer. Remove the

bolt from the left switch housing. Put the bolt through the hole on the switch bracket, then the

spacer, then into the switch housing and tighten (center picture below).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

No comments

Yamaha ROADLINER XV19SC Installation Manual Page 13