Yamaha 2100E - CRW - CD-RW Drive User Manual download pdf (Page 25)

to poor quality of DVD disc or unstable writing under high

speed. Under this circumstance, please lower the write

speed under this setting. Please note that this is not the

problem of the controller itself.

There is also situation that un-authorized blank DVD disc

will be locked and restricted in some DVD writers to write at

higher speed. This situation is not under Wytron’s control.

Press MODE to change the setting and GO to exit.

6.1.5 show drives

This setting shows the devices connected to the duplicator

such as CD/ DVD-ROM, CD/DVD writers and hard drive,

etc. It also displays the devices’ firmware version that

sometimes provides a useful hint for trouble shooting or for

future upgrade. It is suggested to use writers with SAME

firmware version to avoid inconsistency. The display is as

below:

DVD-ROM

[*] ATA1.0 1.22 [Q]

It means the first slot (IDE#1) on controller board is

connected with DVD-ROM that is set to master mode (0)

and its firmware version is 1.22.

ATAPI DVD+RW 4X4X

[*] ATA7.1 B1HY [Q]

It means the 7

slot (IDE#7) on the controller board is

connected with ATAPI device DVD+RW writer that is set to

slave mode (1) and its firmware version is B1HY. The first

digit after ATA is slot number and the digit behinds the dot

is master and slave mode, 0 for master and 1 for slave.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 48 49

No comments

Yamaha 2100E - CRW - CD-RW Drive User Manual Page 25