4 - 89
ENG
2. Remove:
• universal joint
▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Remove the circlips 1.
b. Place the universal joint in a press.
c. With a suitable diameter pipe 2 beneath
the yoke 3, press the bearing 4 into the
pipe as shown.
NOTE:
It may be necessary to lightly tap the yoke with
a punch.
d. Repeat the steps for the opposite bearing.
e. Remove the yoke.
NOTE:
It may be necessary to lightly tap the yoke with
a punch.
▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
3. Remove:
• nut 1
• washer
• universal joint yoke
NOTE:
Use the universal joint holder 2 to hold the
universal joint yoke.
Universal joint holder
P/N. YM-04062, 90890-04062
MIDDLE GEAR
Comments to this Manuals