1980 SRX440
d. Install the drive and driven sprockets
with
chain.
Place the collar
into
the
drive sprocket.
Tighten the drive
sprocket
nut
and
driven sprocket
bolt.
and install a
new
cotter
pin on the secondary shaft.
Tightening torque:
Drive sprocket nut:
50
Nm (5.0 m-kg)
Driven sprocket
bolt:
50
Nm (5.0 m-kg)
1. Oil level screw
e. Install
the
chain housing gasket and
chain housing cap.
NOTE:-----~----____,____
Check the gasket. and
if
damaged. replace
with
a
new
one.
Tightening torque:
16 Nm (1.6 m-kg)
f. To add gear oil.
the
filler
cap and oil
level
screw
should be removed.
Fill
until
oil begins to run
out
the
screw
hole.
Recommended oil:
Gear oil API
"GL-3"
SAE
#75
or
#80
Quantity:
320
em'
After
adding
oil.
be sure to install and
g. Chain tension
adjustment
Remove adjuster
bolt
clip. Tighten ad-
juster
bolt
(turn clockwise) by hand
until
nearly
tight.
Then
tighten
or loosen
slightly
to align clip hole
with
clip stop-
per. Install clip.
1. Adjusting bolt
h. Tighten
the
bearing inner race by using
eccentric bearing installer.
Comments to this Manuals