8. Piston pin and bearing inspection
a. Check
the
pin
for
signs
of
wear. If any
wear
is evident. replace pin and bearing.
1980 SRX440
Tightening torque:
First:
10
Nm (1.0
m-kg)
Final:
22
Nm (2.2
m-kg)
Tightening
torque:
40
Nm
(4.0 m-kg)
.
c.
After
reassembly,
apply
a liberal coating
of
two-stroke
oil
to
the
crank pin, bear-
ing and
into
each crankshaft bearing oil
delivery hole.
d. Check crankshaft
for
freedom
of
move-
ment.
7. Engine bracket
installation
Install the engine brackets in
the
correct
position.
2-8
b. Check the pin and bearing
for
signs
of
heat
discoloration. If excessive (indenta-
tion
on pin, etc.). replace pin and bear-
In.
c. Check
the
bearing cage
for
excessive
wear
or damage. Check the rollers
for
signs
of
flat
spots. If such
wear
is found,
replace pin and bearing.
d.
Apply
a
light
film
of
oil to pin and bear-
ing surfaces. Install
them
in connecting
rod small end to
inspect
for
wear. Check
for
play. There should be no noticeable
vertical play. If play exists, check con-
necting
rod small end
for
wear. Replace
pin,
connecting
rod
and/or
bearing, as
required.
Comments to this Manuals