Yamaha RX-V1800 Manual download pdf (Page 39)

37 En

PREPARATION

English

This unit employs the YPAO (Yamaha Parametric Room Acoustic Optimizer) technology which lets you avoid troublesome

listening-based speaker setup and achieves highly accurate sound adjustments automatically. The supplied optimizer

microphone collects and this unit analyzes the sound your speakers produce in your actual listening environment.

• Be advised that it is normal for loud test tones to be output

during the “AUTO SETUP” procedure.

• To achieve the best results, make sure the room is as quiet as

possible while the “AUTO SETUP” procedure is in progress. If

there is too much ambient noise, the results may not be

satisfactory.

• We recommend that you get out of the room while this unit is in

the automatic setup procedure. Keep quiet when you leave the

room. It takes approximately 3 minutes for this unit to complete

the automatic setup procedure.

• The initial setting for each parameter is indicated in bold.

• Before performing operations, set the operation mode selector

on the remote control to

AMP.

■ Basic procedure of the automatic setup

1 Make sure of the following check points

before starting the AUTO SETUP operations.

❏ Speakers are connected appropriately.

❏ Headphones are disconnected from this unit.

❏ This unit and the video monitor are turned on.

❏

The connected subwoofer is turned on and the volume

level is set to about half way (or slightly less).

❏ The crossover frequency controls of the

connected subwoofer is set to the maximum.

❏ If you use the external amplifiers (see page 29),

the amplifiers are turned on and the settings are

appropriate.

❏ The room is sufficiently quiet.

2 Connect the supplied optimizer microphone

to the OPTIMIZER MIC jack on the front

panel.

“MIC ON” and “View OSD Menu” appears in the

front panel display.

The following menu screen appears on the video

monitor.

You can also run “AUTO SETUP” using the system menu

that appears in the front panel display. When you connect

the optimizer microphone to the OPTIMIZER MIC jack, the

following display appears in the front panel display. This

manual uses the OSD illustrations to explain the “AUTO

SETUP” procedure.

3 Place the optimizer microphone at your

normal listening position on a flat level

surface with the omni-directional

microphone heading upward.

It is recommended that you use a tripod (etc.) to affix the

optimizer microphone at the same height as your ears would

be when you are seated in your listening position. You can

use the attached screw of a tripod (etc.) to fix the optimizer

microphone to the tripod (etc.).

Optimizing the speaker setting for your listening room

Using AUTO SETUP

Notes

SLEEP

ZONE ON/OFF

ZONE CONTROLS

MULTI ZONE

MIC

OPTIMIZER

EFFECT

PROGRAM

YPAO

ZONE 3

OPTICAL

ZONE 2

AUDIO

VIDEO AUX

SILENT CINEMA

S VIDEO

VIDEO

PHONES

MODE

TUNING

PRESET/TUNING

EDIT

FM/AM

TUNING

PRESET/

MAN'L/AUTO FM

MEMORY

STRAIGHT

CONTROL

SELECT

AUDIO

TONE

A/B/C/D/E

Omni-directional

microphone

[]/[]:

[ENTER]:

[

AUTO SETUP

SETUP;;;;;;;;;AUTO

WIRING;;;;;;;CHECK

DISTANCE;;;;;CHECK

SIZE;;;;;;;;;CHECK

EQ;;;;;;;;;NATURAL

LEVEL;;;;;;;;CHECK

START

UP/DOWN

Start

AUTO SETUP

ENTER TO START

Optimizer microphone

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 564 565

Comments to this Manuals

No comments

Yamaha RX-V1800 Manual Page 39

Comments to this Manuals

Related products and manuals for AV receivers Yamaha RX-V1800